How do I restore a cisco switch to factory settings?
Hold the “mode” button on the front of the switch for 10 seconds. The lights will blink then go solid – the switch completely wipes all configuration and then reboots.
How do I clear my cisco router configuration?
Enter configure terminal to go to Global Configuration Mode. Enter config-register 0x2102. Enter end, and then enter the write erase command to delete the current startup configuration on the router. Enter reload to reload the router.
How do I Reset my wireless access point?
Resetting the access point using the Reset button Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle. Unplug the access point’s power cable and wait for 30 seconds then plug it back in. Wait for the access point’s lights to appear solid.
How do I Reset my cisco router to factory default?
Reset Router to Default Configuration
- With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
- Find the Reset button on the router.
- Press and hold the Reset button while you power on the router.
- Release the Reset button after 10 seconds.
How do I reset my cisco router password without losing the configuration?
Reboot the router using the power switch. Press BREAK on the console terminal. When rommon>1 appears on the screen enter confreg 0x2142 comand to restart from the flash (This step skips the start-up configuration where the passwords are stored). Enter the RESET command when rommon2 > appears on the display.
How do I find the password for my cisco wireless router?
I forgot my WIFI Router password….Windows 7: Find your password.
| Step 1: | Click the wireless network icon on the taskbar (lower-right corner). |
|---|---|
| Step 2: | Right-click your wireless network name, and then select Properties. |
| Step 3: | Select Show characters to see the wireless network password. |
How do I Reset my Cisco access point password?
1. Press and hold the MODE button while you reconnect power to the AP. 2. Hold the MODE button until the Status LED turns amber (approximately one to two seconds), and release the button.