Who bought out Stanley garage door openers?
The $90 million-a-year operation was sold last month by the Stanley Works, a New Britain, Conn. -based maker of tools and hardware, to Whistler Corp., a major producer of radar detectors and automotive security systems based in Chelmsford, Mass.
When did they stop making Stanley garage door openers?
2001
Stanley garage door openers were a household name from the 70s until the early 2000s until the company that manufactured them went out of business in 2001.
Does Stanley still make garage doors?
Stanley Black and Decker Corporation no longer manufactures garage doors/openers or related parts nor do we have the ability to repair, service or provide advice regarding these products.
How do you read a Stanley date code?
Brand names, model designations and date codes are as follows: – Stanley units affected have date codes 91-04-1 through 91-15-5. The date code is designated on a data plate located on the end panel at the back of the power unit. See illustration below.
Why is the garage remote not working?
The most common cause for remote not working is dead batteries. So, check the batteries first! Access the batteries by opening the panel on the back. If your device has screws, remove them and open the panel.
How do you read the date code on a Stanley garage door opener?
How do I change the code on my Stanley garage door opener?
Press the “Radio Learn” key on the keypad twice if you have a digital opener. The indicator light will stay on. Enter your PIN which you just set and then enter the radio code from the garage door opener. Press the “Radio Learn” key to set the radio code.
What is the useful life of a garage door opener?
about 10 to 15 years
Garage Door Opener Lifespans The opener actually has a similar lifespan to the other parts of your garage door — it should last about 10 to 15 years. Also, like the other parts of your garage door, this lifespan depends on several factors like how often you use the opener and how often you repair it.
How tight should the chain be on a garage door opener?
The chain should be tightened until it sits, at its midpoint, about a quarter-inch above the rail for a square rail and a half-inch above the rail for a T-rail. It’s important that you don’t over-tighten it, as this will cause the chain rollers to wear out prematurely.