How do I reset my ScreenLogic interface protocol adapter?
Cycle the power to both of these devices. unplug and plug back in the wireless router to reset it.
How do I reset my Pentair ScreenLogic app?
You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. You canunplug and plug back in the wireless router to reset it.
How do I connect my ScreenLogic interface protocol adapter?
Using the provided connection cable, connect one end of the cable to the ScreenLogic Interface Protocol adapter and the other end to the ScreenLogic Interface indoor wireless transceiver. The cable plugs are keyed for easy connection.
Can’t connect to ScreenLogic?
The simple solution was insert a paperclip into the reset hole on the side of the protocol adapter and click the internal reset button three (3) times. That’s right, not just once, but click the reset button 3 times. I waited 30+ seconds, then opened up the Screenlogic Connect software.
How do I Reset my Pentair screenlogic protocol adapter?
You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. Click to see full answer. Regarding this, how do I update my Pentair ScreenLogic? STEP 1: UPDATE YOUR PROTOCOL ADAPTER The firmware version can be found on the label on the side of the protocol adapter.
How do I set up my IP address in screenlogic connect?
Once the ScreenLogic Connect screen is up, using the same System Name and Password as earlier, select options. Your brick should appear in the Local Systems box. Highlight that name and select ‘Configure IP Info’.
Why can’t I connect to older systems with screenlogic connect?
If you have a need for connecting to older systems with your newly installed copy of ScreenLogic Connect, you may have problems unless you run the compatibility update below. This update will allow version 738 ScreenLogic Connect to work with protocol adapters still running version 736, 733, and 724.
How do I start screenlogic from the control panel?
At the login screen connect to the brick Using the Hex Code located on your brick for Username (Pentair: xx-xx-xx) and the numbers on the yellow sticker on the brick for the password. 5. Click Start ScreenLogic. It should load and now talk to your control panel outside. Try turning on your pump, etc to make sure commands work.