How do I install Platon?
Begin Installation Platon can be sawn to height while rolled up. Standing the roll on the footing when unrolling Platon is easiest. Excess membrane (if any) may be folded out and cut even with the footing edge. Crease the Platon sharply at the footing/wall corner and lay flat on the footing to prevent pull-down.
How do you speed up waterproofing membranes?
It is important to fit the membrane tightly to corners. Fasten the membrane near the top and bottom by inserting washers at least 6 inches (15 cm) back from outside corners and 6 inches (15 cm) from inside corners. (Fastening the membrane too close to outside corners can cause the corner to crack.)
How does Dimple mat work?
When a dimple mat is placed against a concrete wall, the dimples make the plastic stand out from the wall, leaving a free-draining air space between the plastic and the concrete. If any water reaches this air space, it easily flows to the bottom of the dimple mat.
What is the purpose of dimple board?
An Effective Method of Controlling Water The DRY-UP™ Dimple Board is a very tough and long lasting plastic membrane that prevents moisture from passing through. It is also “dimpled” to allow a wall to breathe, allowing moisture to condensate outward so it falls by gravity to a drainage system.
How do I waterproof my exterior foundation?
How to waterproof house foundations from the outside
- 1 – Excavate the ground around the perimeter of the foundations.
- 2 – Seal all cracks in the concrete.
- 3 – Attach a waterproofing membrane to the outside of the foundation.
- 4 – Backfill the trench dug around the foundations.
How do you waterproof a concrete foundation wall?
The Best Approach to Waterproofing New Foundation Walls is Poly Wall® Waterproofing Barrier Systems. Applying Poly Wall® below-grade waterproofing systems to any foundation wall with earth on one side and usable space on the other (including crawl spaces) significantly minimizes moisture-related problems to your home.
What is Delta membrane used for?
The Foundation Protection System that Keeps Basements Dry Protecting your foundations from water and moisture is critical. DELTA®-MS is a dimpled membrane that uses our exclusive Air-gap Technology to ensure your basements stay dry and last longer.
How do you apply blue skin?
Install Blueskin per dia- gram, adhering to the window head flange and sheathing. Upon completion of Steps 6, 7, and 8, using a J-roller, apply pressure and roll entire surface of Blueskin to remove wrinkles and air pockets. Consult with builder or design consultant on how to interface building wrap at jambs and head.
What is dimpled membrane used for?
What is it used for? SUPERSEAL Dimpled Membrane is a permanent waterproofing and drainage membrane that can be installed on any type of foundation, used as a subfloor, under floor slabs, and retrofit applications.
What is Dimple Matt?
What is a dimple mat? A dimple mat is a sheet of semi-rigid plastic (usually high-density polyethylene) that comes in a roll. The plastic has an egg-carton shape, with protruding dimples that make the membrane fairly thick — generally between 1/4 inch and 1/2 inch thick.
What is the best way to waterproof a foundation?
What is the loading capacity of Delta MS20?
150kn/m2
Delta MS20 has a maximum load capacity of 150kn/m2 meaning. This means that it can support the weight of dry lining, most blockwork walls as well as plant equipment.
How do you waterproof an ICF basement?
The primary methods of waterproofing are:
- Peel-and-stick membranes.
- Liquid systems that are sprayed, rolled, or applied with a trowel, and.
- Dimpled drainage mats which are mechanically fastened to ICF walls.