How do I set public channels on DStv DSD 3u?

Set Signal Setup to “Dstv IS20” if it is on “Disabled” by scrolling to left or right. After Scanning press TV button on top left of your DStv remote and select public. Thereafter you’ll be able to access all the public channels. Call 0789186069 for further help.

Table of Contents

Can I trade in my old DStv decoder?

You will keep accessing DStv for as long as your older Single View decoder is still working. You can, however, trade-in your active Single View decoder at any of our service centres or agencies for a brand new DStv HD Decoder for only R449.

How do I check my DStv network settings?

Press MENU on Your DSTV Remote Control

then Go to ADVANCED OPTIONS – press OK.
When Prompted, you need to Enter Pin code 9949.
Go to NETWORK SETUP press OK.
Home Network Dstv IS20 PLEASE DO NOT CHANGE THE DEFAULT VALUES (Frequency should be 11594 and Symbol rate 27500 )
Press P+ button on the remote to access new networks.

How do I connect my DStv decoder?

Connect the cable from the satellite dish directly to the LNB input on the back of the decoder. Connect either cable from the satellite dish directly to the LNB input on the back of the decoder. Connect any one of the four cables from the satellite dish directly to the LNB input on the back of the decoder.

Can I use someone else DStv decoder?

Yes you can but it’s important for you to note that if your decoder is an older model which is at the end of its lifecycle, we cannot fix or replace it with the same model decoder if it breaks. You cannot take out insurance on this decoder.

Can you put your DStv card in another decoder?

No, you cannot use your Dstv Smartcard in another decoder, as each Multichoice IUC is paired to only one Dstv box. So you can not watch Dstv on another decoder with your Smart card.

How do I scan for signal on DStv?

If you are comfortable doing it by yourself, then here is how to find channels on DStv:

Use the DStv remote.
Press the menu button on the remote.
Go to the menu.
Select satelite installation.
Make sure the DStv signal indicator is on for the frequency you are scanning.
Scan the frequency for new channels.

How do I fix DStv no signal?

Fix a DStv no signal error by following the steps below:

Step 1: Check your DStv connection cables. This is one of the easiest checks you can do on your own.
Step 2: Reboot your decoder.
Step 3: Inspect your DStv satellite dish.
Step 4: Check your LNB.
Step 5: Call the approved DStv installer.

How do I scan my DStv signal?

How to Check and Detect the Problem Causing Poor Signal Quality. Once you encounter a poor signal error, you can press the HELP button on your remote and click on General Information. Then, click on Select Tuner Status Signal Quality & Strength. Here you will be able to view the strength of the signal.

Why is my DStv decoder not working?

Press and hold the power button on the decoder for about 30 seconds. The lights will blink and the device will load and start properly. If this does not work, remove and put back the HDMI properly and test it again. Related Post: How to carry out Change of Ownership for a DStv Decoder.

Can I put my DStv card in another decoder?

Can DStv work without a smart card?

Without the smart card, you can not watch any channel. It is a DStv decoder identity number at the customer care center. It is used for subscribing to any packages you wish.

What causes DStv not to scan?

The main cause for my DStv decoder is not scanning error message is a poor signal reception by your decoder. Often, the problem comes from your satellite dish or smart LNB. If they are installed incorrectly, you will get this error message. It is common in DIY dish installations where the right tools weren’t used.

How do I fix no signal on DStv?