How do you reset the code on a Kenmore washing machine?

How to Reset the FH Error Code on a Kenmore Elite Washing Machine

Table of Contents

Look for the “Pause/Cancel” button on the washer control panel.
Press the “Pause/Cancel” button twice to cancel the wash cycle.
Check for kinks in the water supply hose while the washer does not have power.

How do I fix my f11 duet whirlpool?

Whirlpool washer error code f11

Check the integrity of the harness connection with the motor control panel, motor, and central control panel.
Analyze moving parts for worn out or broken components.
Check the motor control panel. Examine the main control panel of the Whirlpool washing machine. Test the engine.

What is an f11?

The F11 key is a function key found at the top of almost all computer keyboards. The key is most often used to Enter and exit fullscreen mode in all modern Internet browsers. F11 also has other uses depending on the computer and program, as mentioned below.

How do you drain a Kenmore washing machine?

Squeeze the locking pin on the end of the drain hose that is connected to the back of the washer if you will be draining the water into a floor drain. Pull the hose away from the washer to disconnect it. The water will pour out as soon as the hose is disconnected.

What does F mean on my Kenmore Elite washer?

The cold water goes through a mesh screen and often gets clogged. The code usually goes off during the begging of the rinse cycle or at the end. This is when the cold water is most commenly used. YOu have to clean this screen.

How do I force my Kenmore washer to drain?

How do I reset my Whirlpool Duet washer?

Unplug the washer for 30 seconds to attempt to reset the Duet washer control. if your fill hoses have a flood stop check valve turn the water off, disconnect the hoses and run a little water into a bucket. Then reconnect the hoses to your washer and do a Duet Washer Quick Diagnostic Test.

What is shift F11?

Shift+F11: Jump to the previous field in your document. Ctrl+F11: Lock a field so it cannot be edited.

How do you run a diagnostic on a Kenmore front load washer?

3 Answers

With the washer empty, close the door.
Push “control/on” or “Start”
Select “Drain/Spin”
Select “No Spin” by pressing SPIN SPEED touchpad.
Push “PREWASH” option four times within 5 seconds. (If there is no PREWASH option, press RINSE HOLD 4 times in 5 seconds.)
C:00 should light up and begin the diagnostic.